Table of Contents
Advertisement
ASSEMBLY
Tool:
10
11
50 60
60 50
7
33
54
57
Wrench
43
26
24
Allen Wrench 6mm
44
32
54 57
5
44
24
Allen Wrench with
54 57
5
Phillips Screwdriver 5mm
Step 3
Lift the front end of Main Frame (5) up by two or more people and then
attach the Main Frame (5) onto the Left/Right Handlebar Support Tubes
(10, 11) with two M10x55mm Bolts (50) and two M10 Washers (60).
Tighten bolts with the 6mm Allen Wrench provided. Please do not fully
tighten the bolts until the handlebars are installed.
Connect the Sensor Wire (32) from the Main Frame (5) to the Extension
Sensor Wire I (33) from the Right Handlebar Support Tube (11).
Remove one M8x35mm Bolt (44), one Ø8.2xØ16x2T Nylon Washer (54),
and one M8 Nylon Nut (57) from the Safety Tube A (24).
Remove bolt
and nylon nut with the 5mm Allen Wrench with Phillips Screwdriver and
Wrench provided.
Remove one M8x40mm Bolt (43), one Ø8.2xØ16x2T Nylon Washer (54),
and one M8 Nylon Nut (57) from the Safety Tube B (26).
Remove bolt
and nylon nut with the 5mm Allen Wrench with Phillips Screwdriver and
Wrench provided.
Fold up the Main Frame (5) and hold it by one person, release the Spring
Knob (27) by the other person and pull the Safety Tube A (24) to
stretched-out. Attach the Safety Tube B (26) onto the L-plate on the
Base Frame (7) with one M8x40mm Bolt (43), one Ø8.2xØ16x2T Nylon
Washer (54), and one M8 Nylon Nut (57) that were removed.
11
Advertisement
Table of Contents
