Operation Instructions; Power On; Binding - Fly Sky FS-i10 Instruction Manual

Digital proportional radio control system

4. Operation Instructions

Follow these guidlines to ensure proper use of your system

4.1 Power On

Follow these steps to power on the system:
1. Check the system and make sure that:
• The battery is fully charged and installed properly. 。
• The receiver is off and correctly installed.
2. Hold both power buttons on either side of the LCD until it lights up
3. Connect the receiver power supply to the B/VCC port on the receiver.
Note • Use with caution to prevent damage, injuries or death.
• As a safety precaution, the system will not power on unless all the switches are in
Note
• their highest position and the throttle is at its lowest position.

4.2 Binding

The transmitter and receiver have been pre-bound before delivery.
If you are using another transmitter or receiver, follow the steps below to bind the TX and RX:
1. Turn on the transmitter, enter the main
menus, swipe from right to left and select [RX
Settings]
2. Check the chart below to find out what RF
standard your receiver is using. To change enter
the [RF std] menu, press yes when prompted
and select the corresponding RF protocol from
the list.
RF Standard Receiver Type
AFHDS GR3F, GR3E, R6B, R9B，R6C
AFHDS 2 iR4, iR4B, iR6B，iR10
AFHDS 2A 1-way A3, A6
AFHDS 2A 2-way iA4B, iA6, iA6B, iA10, iA10B，X6
3. Select [Bind with a receiver] and press [Yes]
to enter bind mode.
10
14
Receiver
4. Connect the bind cable to the B/VCC port of the
receiver.
5. Connect the power to any other port. The indicator
will start to flash, indicating that the receiver is in
bind mode.
• For [AFHDS 2A 2-way], once binding is
complete, the transmitter should exit the bind
menu automaticlly.
• For other protocols, select the back button to
exit the bind menu.
6. Remove the bind and power cable from the receiver.
Then connect the power cable to the B/VCC port.
7. Check the servos' operation. If anything does not
work as expected, restart this procedure from the
beginning.
Bind cable
FS-l10
Battery