4Ghz Operation Notes; Binding; Adjustment Of The Antenna - Fly Sky FS-T6 Instruction Manual

Digital propotional radio control system
10.

2.4GHz Operation notes

10.01.

Binding

The supplied transmitter and receiver are already bound at production time so you don't need to do it. If you are
using another transmitter or receiver, you have to first bind them before use as described below:
1. Install batteries in the transmitter and turn it off.
2. Connect the binding jumper to the battery port of the receiver.
3. Connect the battery of the receiver to any channel power supply. The red LED with blink indicating that it is in
binding mode.
4. Press and hold the bind key of the transmitter and turn it on.
5. The red LED of the received should stop to blink meaning a successful binding.
6. Disconnect the receiver battery.
7. Turn off then back on the transmitter.
8. Connect all the servos to the receiver and then connect its battery.
9. Check if all servos are working as expected.
10. If anything is wrong, restart this procedure from the beginning.
对码:
所有遥控产品在出厂的时候都已经对好码，您无需再次
对码。如果您需要和其他发射机或接收机对码， 您必须在使
用前按照以下方法对码：
1. 将电池装入发射机然后关闭发射机。
2. 将对码线插到接收机电池通道插口。
3. 将 接收机 电池连接至接收机任意通道，接收机红色指
示灯闪烁表明处于对码状态。
4. 按住发射机对码按键不松手，同时打开发射机。
5. 接收机红色指示灯停止闪
6. 断开接收机电源。
7. 关闭发射机电源。
8. 将所有舵机连接至接收机,然后就将电池连接到接收机。
9. 检查是否所有的舵机按照要求工作正常。
10. 如果对码失败,请按以上步骤从头再来。
10.02.

Adjustment of the antenna:

Adjustment of the antenna:
There are two correct ways to adjust the antenna. Please strictly respect the following illustration as test results
show that it is the safest and most efficient way to control your model.
关于2.4G天线摆放标准:
2.4G天线正确摆放方式有以下两种，请参照下图所示严格执行。此两种方式经测试能最大安全、最有效的控制您
的模型产品。
1
对码
烁 表明对码成功。
2
2.4G操作注意事项
Binding jumper
天线调整
FS-T6
Bind key
Figure(图2 )
8