4. Operation Instructions
After setting up, follow the instructions below to operate the system.
4.1 Power On
Follow the steps below to turn on the system:
1.
Check the system and make sure that:
▫
The battery is fully charged and installed properly.
▫
The receiver is correctly installed.
2.
Hold the power button until screen lights up.
3.
Connect the receiver power supply.
The system is start now. Operate with caution, or serious injury could result.
4.2 Binding
The transmitter and receiver have been pre-bound before delivery. If you are using another transmitter or
receiver, follow the steps below to bind the transmitter and receiver:
1.
Make sure a battery is installed in the transmitter and that the transmitter is turned off.
2.
Connect the bind cable to the B/PPM connector of the receiver.
3.
Connect the power to any of the CH1 to CH4 connectors. The indicator will start to flash, indicating
that the receiver is in binding mode.
4.
Turn the transmitter on and navagate to [RX Setup]
on the screen and selecting the RX setup icon. Select [Bind with a receiver] and press yes to enter
bind mode.
5. On the receiver, connect the bind cable into the bind port and connect the power. Once the binding is
complete the transmitter should exit the bind menu automaticlly (Note: This only applys to two-way
communication protocols).
6.
Remove the bind cable from the receiver.
7.
Check if all the servos work as expected. If anything is doesn't work as expected, restart this procedure
from the beginning.
4.3 Pre-use Check
Before operation, perform the following steps to check the system:
1.
Check to make sure that all servos and motors are working as expected
2.
Check operating distance distance: one operator holds the transmitter, and another one moves the
model away from the transmitter. Check the model and mark the distance from where the model
starts to lose control. (Note: Sources of interference may affect signal quality)
Danger
•
Stop operation if any abnormal activity is observed.
Danger
•
Make sure the model flies within the safe distance.
by pressing
and swiping from right to left
11