4.3 Preflight Inspection
Before you begin, perform the following steps to ensure the system performs as expected:
1. Check the entire system to ensure that all components function as expected.
2. Perform a distance signal test as outlined in 【9.13 Range Test】.
Danger
•
If there are any problems during testing, no not operate the model.
Danger
•
Make sure that the model does not go outside safe operating range.
Attention •
Be aware of sources of interference that can affect signal quality.
4.4 Model Setup
This system supports fixed-wing, glider and helicopters. To set up your model follow these steps:
1.
Select model type: Enter the [Model] function, for more information on this fuction reference
【6.25Models】.
•
After a model type is selected the system will automaticlally open the [aircraft structure] menu.
•
Fixed-wing and glider are the same option. Choose your model parts from the list.
2. Model Structure Setup:
If [Airplane / glider] is selected, see 【6.20Airplane Structure】 for details;
If [Helicopter] is selected, see【8.9 Helicopter Structure】 for details.
•
Once the model structure has been set the system will set a default channel assignment for the
model. Check the model stucture diagram to make sure that the receiver is connected correctly.
4.5 Power Off
Follow these steps to turn off the system:
1. Disconnect the receiver's power.
2. Hold both of the transmitter's power buttons to turn off the transmitter.
•
Make sure to disconnect the receiver power before turning off the transmitter.
Danger
Failure to do so may lead to damage or serious injury.
11