Table of Contents
Advertisement
Digital proportional radio control system
6.4 Trims
(Pic.8)
There are 4 groups of trim
switches affecting surface
position. Each time a
trim is toggled, the trim
will move one step. You
can hold the trim in the
desired direction to make
quicker trim adjustments.
When the trim position
reaches the middle, the
transmitter beeps in a
higher tone.
•
This function can
be set with up to
5 conditions.
6.5 Exponentials
(Pic.9.1
This function changes channel's response curves.
There are 2 main parameters:
Dual Rate: Dual Rate reduces or increases the
difference between the highest and lowest possible
value, for example if applied to the rudder,
throw of 60 degrees)
before changing the settings,
when you move your stick to 1/2 you would get 30
degree rudder movement, if you move the stick 1/4
of the way, the rudder will move 2.5cm, so at 100%
there is a direct, linear relationship of stick movement
and surface movement.
If a setting of 50% is entered then moving the stick
all the way in one direction will only give 1/2 of the
surface movement and 1/2 stick movement will only
produce 1/4 surface movement, this has the effect
of reducing how responsive the rudder is when
the stick is moved, effectively reducing the range
of movement available to the servo. This function
is usually assigned to a condition so that it can be
turned on and off during flight.
Exp. (Exponential): Exponential changes the
relationship between stick movement and surface
movement by creating a curve, when in use the stick
movement and surface movement are no longer
linear so the stick has a different response in different
at different positions. For example this is useful when
needing less reaction during a take-off but more
reaction when in the air.
Changes to the rate and exponential can be seen
on the graph located in the center of the screen.
The system also gives a real-time readout of the
channel's current position.
16
Pic.8
9.4)
-
(set to a
•
The system gives a real time
readout of the channels
position, not the servo
position. The servo will not
Note
correlate with the graph if the
rate is under 100% ,or another
function like trim has made
changes to the channel's
movement and/or outer limit.
Pic.9.1
Setup:
1. Select a curve type by touching the curve menu
icon
, select yes, then a curve type.
2. Touch [Rate] or [Exp] to select.
3. Move the wheel to change the value.
•
On/Off, Dual, Rate and Exp can be assigned
to switches or knobs. Both On/off and Dual
can only be set to switches, where as Rate
and Exp can be set to knobs.
Switch/Knob Setup:
1. To assign these functions first touch the switch
assignment icon
.
2. Select and option from the list.
3. Selct a switch/knob.
•
This function must be set as active before
use.
•
This function can be set with up to 5.
FS-l10
Pic.9.2
Hide quick links:
Advertisement
Table of Contents
