Do you have a question about the FS-T6 and is the answer not in the manual?
Questions and answers
Martin Harris
March 26, 2025
The receiver light just flashes once
1 comments:
Mr. Anderson
March 26, 2025
The Fly Sky FS-T6 receiver light flashes when it is in binding mode and waiting to be paired with the transmitter. If the light flashes only once and does not stay on or continue flashing, it could indicate one of the following issues:
1. Incorrect Wiring – Ensure that the negative and signal wires are connected correctly as described. 2. Binding Procedure Not Completed – The bind key must be held while turning on the transmitter until the light becomes stable. 3. SBUS Mode Issue – If using SBUS mode, ensure the correct settings are applied, or it may not send proper signals. 4. Firmware Compatibility – The receiver may not work with certain firmware versions of Betaflight or Cleanflight.
Checking these factors should help resolve the issue.
This answer is automatically generated
Des Blazely
March 18, 2025
How do I reverse right stick. It’s for rudder on rc yacht
1 comments:
Mr. Anderson
March 18, 2025
To reverse the right stick for the rudder on the Fly Sky FS-T6 remote control, follow these steps:
1. Enter the setup menu by scrolling over to the setup section. 2. Click into the setup menu. 3. Locate the "Reverse" option. 4. Find the channel corresponding to the rudder (typically Channel 4). 5. Select Channel 4 and switch it to "Reverse" mode. 6. Press OK to confirm the change.
Now, the rudder should move in the correct direction when using the right stick.
Need help?
Do you have a question about the FS-T6 and is the answer not in the manual?
Questions and answers
The receiver light just flashes once
The Fly Sky FS-T6 receiver light flashes when it is in binding mode and waiting to be paired with the transmitter. If the light flashes only once and does not stay on or continue flashing, it could indicate one of the following issues:
1. Incorrect Wiring – Ensure that the negative and signal wires are connected correctly as described.
2. Binding Procedure Not Completed – The bind key must be held while turning on the transmitter until the light becomes stable.
3. SBUS Mode Issue – If using SBUS mode, ensure the correct settings are applied, or it may not send proper signals.
4. Firmware Compatibility – The receiver may not work with certain firmware versions of Betaflight or Cleanflight.
Checking these factors should help resolve the issue.
This answer is automatically generated
How do I reverse right stick. It’s for rudder on rc yacht
To reverse the right stick for the rudder on the Fly Sky FS-T6 remote control, follow these steps:
1. Enter the setup menu by scrolling over to the setup section.
2. Click into the setup menu.
3. Locate the "Reverse" option.
4. Find the channel corresponding to the rudder (typically Channel 4).
5. Select Channel 4 and switch it to "Reverse" mode.
6. Press OK to confirm the change.
Now, the rudder should move in the correct direction when using the right stick.
This answer is automatically generated
How do I down load manual on Fly sky ft6
Want to down load Manual
Want to down load manual Fly Sky FS T 6