Appendix B: Front And Back Panels - Zoom X6 User Manual

Appendix B: Front and
Back Panels
The following table describes each light on the top panel.
Light Description
Power Lights when the X6 is plugged into a power source.
DSL Blinks when the X6 is performing its startup
sequence. Stays on solid when the unit has synched
up with its ADSL connection.
Note: If the light fails to switch from blinking to
steady after a minute or two, check with your ADSL
provider that the ADSL connection is activated, or
refer to Appendix D: Troubleshooting Tips
page 72.
Internet Blinks when data is sent and received.
Ethernet Lights when the Ethernet port of the X6 is plugged
into the Ethernet port of a powered-up device.
[1-4]
Blinks when there is data activity.
Lights when the Wireless Local Area Network is
WLAN
running and enabled. Blinks when data is sent.
The following table describes each item on the back panel.
Port Description
DSL Jack to connect the modem to the ADSL telephone
wall jack.
Ethernet LAN ports that can connect the unit to access points,
network hubs, or the Ethernet ports of a computer.
[1-4]
RESET Button to reset the modem to its system default
settings (necessary if communication link is lost).
Power Port to connect the unit to the X6's power cube.
Switch Button when pressed once turns the modem's power
ON. When pressed again turns the modem's power
OFF.

Appendix B: Front and Back Panels

on
65