Locate the battery door on the anemometer transmitter, push and open the battery compartment, as
shown in Figure 3.
Insert four batteries into the battery compartment, then press the reset button, as shown in Figure
4.
Note: Use high quality alkaline batteries, which have an operational temperature range of -4
to 140 °F. Use Energizer e2 Lithium batteries for low temperature installation, which have an
operational temperature range of -40 to 140 °F. Do not use rechargeable batteries. They have a
lower operating voltage and discharge faster than non-rechargeable batteries, and will result in
short transmission ranges.
4.4 Rain Gauge Assembly Set Up
The rain gauge consists of the rain gauge funnel, base, and drawer filter, as shown in Figure 5.
Version 1.1
©Copyright 2016, Ambient LLC. All Rights Reserved.
Figure 3
Figure 4
6
Page