Channel Selection; Sensor Search Mode; History Graph Mode - Ambient Weather WS-12 User Manual

7.4 Channel Selection

Press the CHANNEL/+ button to switch the display between remote sensors 1 through 8, and
scroll mode . In scroll mode, all of the indoor and detected outdoor sensors will be displayed
in five second intervals.

7.5 Sensor Search Mode

If a sensor loses communication, dashes (--.-) will be displayed. If a specific channel is lost,
press the CH/+ button to display that channel prior to entering the search mode.
To reacquire the lost signal, press and hold the CH/+ button for 3 seconds to enter the sensor
search mode.
The icon REG will appear. You can synchronize one or all of individual sensors. Press the [+] or
[-] key to toggle between the following sensors:

CH. Synchronizes Channel 1-8 Sensors (dependent on which channel is displayed before
entering the Sensor Search Mode*).

WIND. Synchronizes Wind Sensor

RAIN. Synchronizes Rain Sensor.

ALL. Synchronizes All Sensors.

NOT. Do nothing and exit the Sensor Search Mode.
After selecting one of the above options, press the SET key to resync, and the display will return
to normal mode. Do not press any buttons until the synchronization is complete. The remote
search icon will display constantly for 3 minutes until the signal is reacquired.

7.6 History Graph Mode

The historical graph on the display changed to display the measured parameters.
In normal mode, press the HISTORY/- key to toggle between:

the wind speed graph (the WIND icon is displayed),

the rainfall graph (the RAIN icon is displayed)

the barometer graph (the BAROREL icon is displayed)

indoor temperature graph (the TEMP-IN icon is displayed)

indoor humidity graph (the HUMI-IN icon is displayed)

outdoor temperature graph (the TEMPOUT icon is displayed)

outdoor humidity graph (the HUMIOUT icon is displayed)
Note: The outdoor humidity and temperature graph will display the history graph of the
Version 1.1 ©Copyright 2016, Ambient LLC. All Rights Reserved.
24
Page