Ambient Weather WS-12 User Manual page 9

Channel Number: The WS-11 supports up to eight transmitters. To set each channel number
(the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in Table 1.
Temperature Units of Measure: To change the transmitter display units of measure (°F
vs. °C), change Dip Switch 4, as referenced in Table 1.
1
DOWN
DOWN
DOWN
DOWN
UP
UP
UP
UP
---
---
2. Insert two AAA batteries.
3. After inserting the batteries, the remote sensor LED indicator will light for 4 seconds, and
then flash once per 60 seconds thereafter. Each time it flashes, the sensor is transmitting
data.
4. Verify the correct channel number (CH) and temperature units of measure (°F vs. °C) are
on the display, as shown in Figure 10.
Version 1.1 ©Copyright 2016, Ambient LLC. All Rights Reserved.
Figure 9
DIP SWITCH
2 3
DOWN DOWN
DOWN UP
UP DOWN
UP UP
DOWN DOWN
DOWN UP
UP DOWN
UP UP
--- ---
--- ---
Table 1
FUNCTION
4
--- Channel 1
--- Channel 2
--- Channel 3
--- Channel 4
--- Channel 5
--- Channel 6
--- Channel 7
--- Channel 8
DOWN °F
UP °C
9
Page