Maintenance; Warning; Battery Replacement; Fuse Replacement - AEMC 1026 User Manual

Maintenance

 For maintenance only use original factory replacement parts.
 To avoid electrical shock, do not attempt to perform any servicing
unless you are qualified to do so.
 Do not perform any service while the megohmmeter is connected to
any circuit.
 To avoid electrical shock and/or damage to the megohmmeter, do not
let water or other foreign agents into the case.
Battery Changing
When
replace the batteries, turn the function selector to the OFF position,
disconnect the megohmmeter from any circuit, then open the battery
compartment cover with a screwdriver. Eight AA 1.5V batteries are
needed. After replacing the batteries, put the cover back on and tighten
the screw.
Fuse Changing:
When connecting the meter under the  range to a source > 10V, the
protection fuse will blow the circuit and a new one will be needed. To
replace the fuse, turn the function selector to the OFF position, disconnect
the megohmmeter from any circuit, disconnect the test leads, remove the
back cover and replace the fuse (F 0.5A 600V).

Cleaning

The megohmmeter may be gently cleaned with a soft damp cloth, with
soap. Dry immediately after cleaning. Do not submerge the case in water.
Make sure the megohmmeter and all leads are perfectly dry before any
further use.
uality Products Online at:

Warning:

appears on the LCD, the batteries will need to be replaced. To
GlobalTestSupply
www.
Digital Megohmmeter Model 1026
- 11 -
.com
sales@GlobalTestSupp