Using Cisco Ios Ip Slas To Measure Network Performance - Cisco Catalyst 3560-X Software Configuration Manual

Chapter 1 Configuring Cisco IOS IP SLAs Operations
•
•
•
•

Using Cisco IOS IP SLAs to Measure Network Performance

You can use IP SLAs to monitor the performance between any area in the network—core, distribution,
and edge—without deploying a physical probe. It uses generated traffic to measure network performance
between two networking devices.
a generated packet to the destination device. After the destination device receives the packet, depending
on the type of IP SLAs operation, it responds with time-stamp information for the source to make the
calculation on performance metrics. An IP SLAs operation performs a network measurement from the
source device to a destination in the network using a specific protocol such as UDP.
Figure 1-1
To implement IP SLAs network performance measurement, you need to perform these tasks:
For more information about IP SLAs operations, see the operation-specific chapters in the Cisco IOS IP
SLAs Configuration Guide:
http://www.cisco.com/en/US/docs/ios/ipsla/configuration/guide/12_4t/sla_12_4t_book.html
OL-25303-03
IP SLAs Responder and IP SLAs Control Protocol, page 1-4
Response Time Computation for IP SLAs, page 1-4
IP SLAs Operation Scheduling, page 1-5
IP SLAs Operation Threshold Monitoring, page 1-5
Cisco IOS IP SLAs Operation
Enable the IP SLAs responder, if required.
1.
Configure the required IP SLAs operation type.
2.
Configure any options available for the specified operation type.
3.
4. Configure threshold conditions, if required.
5. Schedule the operation to run, then let the operation run for a period of time to gather statistics.
6. Display and interpret the results of the operation using the Cisco IOS CLI or a network
management system (NMS) system with SNMP.
Figure 1-1 shows how IP SLAs begins when the source device sends
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Understanding Cisco IOS IP SLAs
1-3