Cisco Catalyst 3560-X Software Configuration Manual page 1004

Configuring Standard QoS
Beginning in privileged EXEC mode, follow these steps to enable the egress expedite queue. This
procedure is optional.
Command
Step 1 configure terminal
Step 2
mls qos
Step 3
interface interface-id
Step 4 priority-queue out
Step 5
end
Step 6 show running-config
Step 7 copy running-config startup-config
To disable the egress expedite queue, use the no priority-queue out interface configuration command.
This example shows how to enable the egress expedite queue when the SRR weights are configured. The
egress expedite queue overrides the configured SRR weights.
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# srr-queue bandwidth shape 25 0 0 0
Switch(config-if)# srr-queue bandwidth share 30 20 25 25
Switch(config-if)# priority-queue out
Switch(config-if)# end
Limiting the Bandwidth on an Egress Interface
You can limit the bandwidth on an egress port. For example, if a customer pays only for a small
percentage of a high-speed link, you can limit the bandwidth to that amount.
The egress queue default settings are suitable for most situations. You should change them only when
Note
you have a thorough understanding of the egress queues and if these settings do not meet your QoS
solution.
Beginning in privileged EXEC mode, follow these steps to limit the bandwidth on an egress port. This
procedure is optional.
Command
Step 1 configure terminal
Step 2
interface interface-id
Step 3
srr-queue bandwidth limit weight1
Step 4 end
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-90
Purpose
Enter global configuration mode.
Enable QoS on a switch.
Specify the egress port, and enter interface configuration mode.
Enable the egress expedite queue, which is disabled by default.
When you configure this command, the SRR weight and queue size ratios
are affected because there is one fewer queue participating in SRR. This
means that weight1 in the srr-queue bandwidth shape or the srr-queue
bandwidth share command is ignored (not used in the ratio calculation).
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the port to be rate limited, and enter interface configuration mode.
Specify the percentage of the port speed to which the port should be
limited. The range is 10 to 90.
By default, the port is not rate limited and is set to 100 percent.
Return to privileged EXEC mode.
Chapter 1 Configuring QoS
OL-25303-03