Cisco Catalyst 3560-X Software Configuration Manual page 1220

Configuring IP SLAs Operations
Command
Step 6
ip sla schedule operation-number
[life {forever | seconds}]
[start-time {hh:mm [:ss] [month
day | day month] | pending | now |
after hh:mm:ss] [ageout seconds]
[recurring]
Step 7 end
Step 8 show ip sla configuration
[operation-number]
Step 9 copy running-config
startup-config
To disable the IP SLAs operation, enter the no ip sla operation-number global configuration command.
This example shows how to configure an ICMP echo IP SLAs operation:
Switch(config)# ip sla 12
Switch(config-ip-sla)# icmp-echo 172.29.139.134
Switch(config-ip-sla-echo)# frequency 30
Switch(config-ip-sla-echo)# exit
Switch(config)# ip sla schedule 5 start-time now life forever
Switch(config)# end
Switch# show ip sla configuration 22
IP SLAs, Infrastructure Engine-II.
Entry number: 12
Owner:
Tag:
Type of operation to perform: echo
Target address: 2.2.2.2
Source address: 0.0.0.0
Request size (ARR data portion): 28
Operation timeout (milliseconds): 5000
Type Of Service parameters: 0x0
Verify data: No
Vrf Name:
Schedule:
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-12
Purpose
Configure the scheduling parameters for an individual IP SLAs operation.
• operation-number—Enter the RTR entry number.
• (Optional) life—Set the operation to run indefinitely (forever) or for a
specific number of seconds. The range is from 0 to 2147483647. The
default is 3600 seconds (1 hour)
• (Optional) start-time—Enter the time for the operation to begin collecting
information:
–
–
–
–
(Optional) ageout seconds—Enter the number of seconds to keep the
•
operation in memory when it is not actively collecting information. The
range is 0 to 2073600 seconds; the default is 0 seconds (never ages out).
• (Optional) recurring—Set the operation to automatically run every day.
Return to privileged EXEC mode.
(Optional) Display configuration values including all defaults for all IP SLAs
operations or a specified operation.
(Optional) Save your entries in the configuration file.
Operation frequency (seconds): 60
Chapter 1
To start at a specific time, enter the hour, minute, second (in 24-hour
notation), and day of the month. If no month is entered, the default is
the current month.
Enter pending to select no information collection until a start time is
selected.
Enter now to start the operation immediately.
Enter after hh:mm:ss to indicate that the operation should start after
the entered time has elapsed.
Configuring Cisco IOS IP SLAs Operations
OL-25303-03