Configuring Ipv6 Acls; Default Ipv6 Acl Configuration; Interaction With Other Features And Switches - Cisco Catalyst 3560-X Software Configuration Manual

Configuring IPv6 ACLs

Configuring IPv6 ACLs
Before configuring IPv6 ACLs, you must select one of the dual IPv4 and IPv6 SDM templates.
To filter IPv6 traffic, you perform these steps:
Step 1 Create an IPv6 ACL, and enter IPv6 access list configuration mode.
Step 2 Configure the IPv6 ACL to block (deny) or pass (permit) traffic.
Apply the IPv6 ACL to an interface. For router ACLs, you must also configure an IPv6 address on the
Step 3
Layer 3 interface to which the ACL is applied.
These sections describe how to configure and apply IPv6 ACLs:
•
•
•
•

Default IPv6 ACL Configuration

There are no IPv6 ACLs configured or applied.

Interaction with Other Features and Switches

•
•
•
•
•
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-4
Default IPv6 ACL Configuration, page 1-4
Interaction with Other Features and Switches, page 1-4
Creating IPv6 ACLs, page 1-5
Applying an IPv6 ACL to an Interface, page 1-7
If an IPv6 router ACL is configured to deny a packet, the packet is not routed. A copy of the packet
is sent to the Internet Control Message Protocol (ICMP) queue to generate an ICMP unreachable
message for the frame.
If a bridged frame is to be dropped due to a port ACL, the frame is not bridged.
You can create both IPv4 and IPv6 ACLs on a switch or switch stack, and you can apply both IPv4
and IPv6 ACLs to the same interface. Each ACL must have a unique name; an error message appears
if you try to use a name that is already configured.
You use different commands to create IPv4 and IPv6 ACLs and to attach IPv4 or IPv6 ACLs to the
same Layer 2 or Layer 3 interface. If you use the wrong command to attach an ACL (for example,
an IPv4 command to attach an IPv6 ACL), you receive an error message.
You cannot use MAC ACLs to filter IPv6 frames. MAC ACLs can only filter non-IP frames.
If the hardware memory is full, for any additional configured ACLs, packets are forwarded to the
CPU, and the ACLs are applied in software.
Chapter 1 Configuring IPv6 ACLs
OL-25303-03