Cisco Catalyst 3560-X Software Configuration Manual page 1269

Chapter 1 Configuring IP Multicast Routing
In populating the multicast routing table, dense-mode interfaces are always added to the table.
Sparse-mode interfaces are added to the table only when periodic join messages are received from
downstream devices or when there is a directly connected member on the interface. When forwarding
from a LAN, sparse-mode operation occurs if there is an RP known for the group. If so, the packets are
encapsulated and sent toward the RP. When no RP is known, the packet is flooded in a dense-mode
fashion. If the multicast traffic from a specific source is sufficient, the receiver's first-hop router might
send join messages toward the source to build a source-based distribution tree.
By default, multicast routing is disabled, and there is no default mode setting. This procedure is required.
Beginning in privileged EXEC mode, follow these steps to enable IP multicasting, to configure a PIM
version, and to configure a PIM mode. This procedure is required.
Command
Step 1 configure terminal
Step 2
ip multicast-routing distributed
Step 3 interface interface-id
Step 4 ip pim version [1 | 2]
Step 5 ip pim {dense-mode | sparse-mode |
sparse-dense-mode}
Step 6 end
OL-25303-03
Purpose
Enter global configuration mode.
Enable IP multicast distributed switching
Specify the Layer 3 interface on which you want to enable multicast
routing, and enter interface configuration mode.
The specified interface must be one of the following:
A routed port: a physical port that has been configured as a Layer 3
•
port by entering the no switchport interface configuration
command.
• An SVI: a VLAN interface created by using the interface vlan
vlan-id global configuration command.
These interfaces must have IP addresses assigned to them. For more
information, see the "Configuring Layer 3 Interfaces" section on
page 1-40.
Configure the PIM version on the interface.
By default, Version 2 is enabled and is the recommended setting.
An interface in PIMv2 mode automatically downgrades to PIMv1 mode
if that interface has a PIMv1 neighbor. The interface returns to Version 2
mode after all Version 1 neighbors are shut down or upgraded.
For more information, see the
section on page 1-11.
Enable a PIM mode on the interface.
By default, no mode is configured.
The keywords have these meanings:
dense-mode—Enables dense mode of operation.
•
• sparse-mode—Enables sparse mode of operation. If you configure
sparse mode, you must also configure an RP. For more information,
see the "Configuring a Rendezvous Point" section on page
sparse-dense-mode—Causes the interface to be treated in the mode
•
in which the group belongs. Sparse-dense mode is the recommended
setting.
Return to privileged EXEC mode.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Configuring IP Multicast Routing
"PIMv1 and PIMv2 Interoperability"
1-24.
1-13