Cisco Catalyst 3560-X Software Configuration Manual page 1189

Chapter 1 Configuring IPv6 Unicast Routing
To disable an OSPF routing process, use the no ipv6 router ospf process-id global configuration
command. To disable the OSPF routing process for an interface, use the no ipv6 ospf process-id area
area-id interface configuration command.
For more information about configuring OSPF routing for IPv6, see the "Implementing OSPF for IPv6"
chapter in the Cisco IOS IPv6 Configuration Library on Cisco.com.
Tuning LSA and SPF Timers for OSPFv3 Fast Convergence
Beginning in the privileged EXEC mode, follow these steps to tune LSA and SPF timers:
Command
Step 1 configure terminal
Step 2 ipv6 router ospf process-id
Step 3
timers lsa arrival milliseconds
Step 4
timers pacing flood milliseconds
Step 5 timers pacing lsa-group seconds
Step 6 timers pacing retransmission milliseconds
Configuring LSA and SPF Throttling for OSPFv3 Fast Convergence
Beginning in the privileged EXEC mode, follow these steps to configure LSA and SPF throttling:
Command
Step 1
configure terminal
Step 2
ipv6 router ospf process-id
Step 3 timers throttle spf spf-start spf-hold
spf-max-wait
Step 4 timers throttle lsa start-interval
hold-interval max-interval
Step 5 timers lsa arrival milliseconds
Step 6 timers pacing flood milliseconds
For more information, see the
OSPFv3 Configuration and
OSPFv3 Fast
Configuration Library on Cisco.com.
OL-25303-03
Purpose
Enters global configuration mode.
Enables OSPFv3 router configuration mode.
Sets the minimum interval at which the software accepts the same
LSA from OSPFv3 neighbors.
Configures LSA flood packet pacing.
Changes the interval at which OSPFv3 LSAs are collected into a
group and refreshed, checksummed, or aged.
Configures LSA retransmission packet pacing in OSPFv3.
Purpose
Enters global configuration mode.
Enables OSPFv3 router configuration mode.
Turns on SPF throttling.
Sets rate-limiting values for OSPFv3 LSA generation.
Sets the minimum interval at which the software accepts the same
LSA from OSPFv3 neighbors.
Configures LSA flood packet pacing.
"Enabling Event Logging for LSA and SPF Rate
Operation," and
Convergence" sections of the Implementing OSPFv3 chapter of the Cisco IOS IPv6
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
"Example: Configuring LSA and SPF Throttling for
Configuring IPv6
Limiting," "Verifying
1-35