Monitoring Enhanced Object Tracking - Cisco Catalyst 3560-X Software Configuration Manual

Monitoring Enhanced Object Tracking

Configuring a Routing Policy and Default Route
Beginning in privileged EXEC mode, follow these steps to configure a routing policy for backup static
routing by using object tracking. For more details about the commands in the procedure, see:
http://www.cisco.com/en/US/docs/ios/12_3/12_3x/12_3xe/feature/guide/dbackupx.html
:
Step 1 configure terminal
Step 2
access-list access-list-number
Step 3
route-map map-tag [permit | deny]
[sequence-number]
Step 4
match ip address {access-list number |
access-list name}
Step 5
set ip next-hop dynamic dhcp
Step 6
set interface interface-id
Step 7
exit
Step 8 ip local policy route-map map-tag
Step 9{ ip route prefix mask {ip-address |
interface-id [ip-address]} [distance] [name]
[permanent | track track-number] [tag tag]
Step 10 end
Step 11
show ip route track table
Step 12 copy running-config startup-config
For configuration examples, see:
http://www.cisco.com/en/US/docs/ios/12_3/12_3x/12_3xe/feature/guide/dbackupx.html
Monitoring Enhanced Object Tracking
Use the privileged EXEC or user EXEC commands in
information.
Table 1-1 Commands for Displaying Tracking Information
Command
show ip route track table
show track [object-number]
show track brief
show track interface [brief]
show track ip [object-number] [brief] route
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-12
Enter global configuration mode.
Define an extended IP access list. Configure any optional
characteristics.
Enter route-map configuration mode and define conditions for
redistributing routes from one routing protocol to another.
Distribute any routes that have a destination network number address
that is permitted by a standard or extended access list or performs
policy routing on packets. You can enter multiple numbers or names.
For DHCP networks only. Set the next hop to the gateway that was
most recently learned by the DHCP client.
For static routing networks only. Indicate where to send output
packets that pass a match clause of a route map for policy routing.
Exit route-map configuration mode.
Identify a route map to use for local policy routing.
For static routing networks only. Establish static routes.
Entering track track-number specifies that the static route is installed
only if the configured track object is up.
Return to privileged EXEC mode.
Display information about the IP route track table.
(Optional) Save your entries in the configuration file.
Table 1-1
Purpose
Display information about the IP route track table.
Display information about the all tracking lists or the specified list.
Display a single line of tracking information output.
Display information about tracked interface objects.
Display information about tracked IP-route objects.
Chapter 1 Configuring Enhanced Object Tracking
to display enhanced object tracking
OL-25303-03