Configuring Eigrp Interfaces - Cisco Catalyst 3560-X Software Configuration Manual

Configuring EIGRP
Command
Step 6
metric weights tos k1 k2 k3 k4 k5
Step 7
offset list [access-list number | name] {in | out}
offset [type number]
Step 8 no auto-summary
Step 9
ip summary-address eigrp
autonomous-system-number address mask
Step 10
end
Step 11
show ip protocols
Step 12 show ip protocols
Step 13 copy running-config startup-config
Use the no forms of these commands to disable the feature or return the setting to the default value.

Configuring EIGRP Interfaces

Other optional EIGRP parameters can be configured on an interface basis.
Beginning in privileged EXEC mode, follow these steps to configure EIGRP interfaces:
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3 ip bandwidth-percent eigrp percent
Step 4 ip summary-address eigrp
autonomous-system-number address mask
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-42
Purpose
(Optional) Adjust the EIGRP metric. Although the defaults have
been carefully set to provide excellent operation in most networks,
you can adjust them.
Setting metrics is complex and is not recommended
Caution
without guidance from an experienced network
designer.
(Optional) Apply an offset list to routing metrics to increase
incoming and outgoing metrics to routes learned through EIGRP.
You can limit the offset list with an access list or an interface.
(Optional) Disable automatic summarization of subnet routes into
network-level routes.
(Optional) Configure a summary aggregate.
Return to privileged EXEC mode.
Verify your entries.
Verify your entries.
For NSF awareness, the output shows:
*** IP Routing is NSF aware ***
EIGRP NSF enabled
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enter interface configuration mode, and specify the Layer 3
interface to configure.
(Optional) Configure the percentage of bandwidth that can
be used by EIGRP on an interface. The default is 50 percent.
(Optional) Configure a summary aggregate address for a
specified interface (not usually necessary if auto-summary is
enabled).
Chapter 1 Configuring IP Unicast Routing
OL-25303-03