Enabling Ipv6 Multicast Routing - Cisco Catalyst 3560-X Software Configuration Manual

Chapter 1 Implementing IPv6 Multicast
•
•
•
•
•
•

Enabling IPv6 Multicast Routing

Beginning in privileged EXEC mode, follow these steps:
Command
Step 1 configure terminal
Step 2 ipv6 multicast-routing [vrf vrf-name]
Example:
Switch(config)# ipv6 multicast-routing
Step 3 copy running-config startup-config
Customizing and Verifying the MLD Protocol
•
•
•
•
•
•
•
Customizing and Verifying MLD on an Interface
Beginning in privileged EXEC mode, follow these steps:
Command
Step 1 configure terminal
Step 2
interface type number
Example:
Switch(config)# interface FastEthernet 1/0
OL-25303-03
Customizing and Verifying the MLD Protocol, page 1-13
Configuring PIM, page 1-19
Configuring a BSR, page 1-24
Configuring SSM Mapping, page 1-26
Configuring Static Mroutes, page 1-27
Using MFIB in IPv6 Multicast, page 1-28
Customizing and Verifying MLD on an Interface, page 1-13
Implementing MLD Group Limits, page 1-15
Configuring Explicit Tracking of Receivers to Track Host Behavior, page 1-16
Configuring Multicast User Authentication and Profile Support, page 1-16
Enabling MLD Proxy in IPv6, page 1-18
Resetting the MLD Traffic Counters, page 1-19
Clearing the MLD Interface Counters, page 1-19
Purpose
Enter global configuration mode.
Enables multicast routing on all IPv6-enabled interfaces and
enables multicast forwarding for PIM and MLD on all enabled
interfaces of the switch.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specifies an interface type and number, and places the switch in
interface configuration mode.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Implementing IPv6 Multicast
1-13