Table of Contents
Advertisement
Changing the tool
Before any work on the power tool itself, pull the mains plug.
With the SDS-max tool holder. Simpler and easier tool changing is possible without additional aids.
The Hammer rod protector1 largely prevents the entry of drilling dust into the tool holder during operation.
When inserting the tool, take care that the Hammer rod protector 1 is not damaged.
A damaged Hammer rod protector1 should be changed immediately. We recommend having this carried
out by an after-sales service.
Inserting (see figure A)
Clean and lightly grease the shank end
of the tool.
Insert the tool in a twisting manner into
the tool holder until it latches itself.
Check the latching by pilling the tool.
Removing (see figure B)
Push back the Protective lining 2 and remove
the tool.
CAUTION: The insert tool may become hot during
Use. There is a risk of burning the hands. Wear
Protective gloves when changing insert tools.
Operation
Observe correct mains voltage! The voltage of the power source must agree with the voltage specified
on the type plate of the power tool.
Switch action
To start the power tool, press the switch.
To stop the power tool, pull the switch fully then release it.
NOTE：
Power tools have the function of preventing start after unexpected
power-off，Into power when the switch is in the "on"state or the
power supply break off，the power tools must re-enable the startup
switch .
If the function failure，please go to the customer service for repair that is commissioned by our Company,
Repairs to the electrical section of the tool may be carried out only by trained electrical specialists.
Advertisement
Table of Contents
