Table of Contents
Advertisement
Name of the parts
1. Hammer rod protector
2. Protective lining
3. Move limited ring
4. Switch Push-And-Pull
5. Speed Adjuster Function Knob
6. Indicator
7. Side Handle
8. Function Knob
Assembly
Auxiliary Handle
Operate your power tool only with the Side Handle7.
The Side Handle 7 can be set to any position for a secure and low-fatigue working posture.
Loosen the Function Knob 8, rotate the Side Handle 7 around the axis of the power tool to the required
position and tighten the Function Knob 8 again.
The Side Handle7 can be mounted to a different position. For this, completely unscrew the Function Knob
8 and then pull out the hexagon bolt upward. Pull off the Side Handle 7 to the side and turn around the
。
remaining clamping element by 180
Mount the Side Handle 7 in reverse order.
Changing the tool
Before any work on the power tool itself, pull the mains plug.
With the SDS-max tool holder. Simpler and easier tool changing is possible without additional aids.
The Hammer rod protector 1 largely prevents the entry of drilling dust into the tool holder during
operation. When inserting the tool, take care that the Hammer rod protector 1 is not damaged.
A damaged Hammer rod protector should be changed immediately. We recommend having this carried
out by an after-sales service.
Inserting (see figure A)
Clean and lightly grease the shank end
of the tool.
Insert the tool in a twisting manner into
the tool holder until it latches itself.
Check the latching by pilling the tool.
Removing (see figure B)
Push back the Protective lining 2 and remove
the tool.
Advertisement
Table of Contents
