Table of Contents
Advertisement
5. Surface Roughing (Hammering)
(1) Bushing Tool
6. Tamping (Hammering)
(1) Rammer
(2) Shank (150 x 150 mm)
Optional accessories are subject to change without notice.
N
ame of the parts
1. Hammer rod protector
2. Protective lining
3. Move limited ring
4. Oil tank cover
5. Shock Absorption system
6. Switch
7. Speed Adjuster Function Knob
8. Indicator
9. Fan cover
10. Side Handle
11. Function Knob
Prior to operation
1. Power source
Ensure that the power source to be utilized conforms to the power requirements which specified on the
name plate of the hammer.
2. Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness and
rated capacity. The extension cord should be kept as short as practicable.
Assembly
Side Handle(with soft synthetic rubber padding)
Operate your power tool only with the Side Handle 10.
The Side Handle 10 can be set to any position(360°circumrotate) for a secure and low-fatigue working
posture.
Loosen the Function Knob 11, rotate the Side Handle 10 around the axis of the power tool to the required
position and tighten the Function Knob 11 again.
(2) Shank
Advertisement
Table of Contents
