Verifying The Installation; Powering On The Switch - HP 830 Installation Manual

Connect the other end of the RPS power cord to an output interface of the RPS.
5.
Figure 34 Connecting the switch to an RPS
(1) RPS power cord plug for the DC power receptacle
(3) AC power input interfaces of the RPS unit
(5) RPS power cord
(7) RPS
Examine the RPS LED on the front panel of the switch. LED ON means the RPS unit is correctly
6.
connected.

Verifying the installation

Before powering on the switch, verify that:
• The power supply system meets the switch requirements.
The grounding cable is correctly connected.
•
Both the console cable and power cords are correctly connected.
•
• All interface cables are routed indoors. If outdoor routing of cables cannot be avoided, verify that
network port lightning arrestors and AC power supply lightning arresters have been correctly
installed.

Powering on the switch

Power on the switch, and you can see the following information:
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU
Booting Normal Extend BootWare
****************************************************************************
(2) DC power receptacle
(4) DC output interfaces of the RPS unit
(6) RPS power cord plug for the RPS output
28