HP 830 Installation Manual page 20

Figure 17 Installing slide rails
Hold the switch by both sides of it, and gently push it into the rack along the slide rails (see
4.
18). Verify that the bottom of the switch is in firm contact with the slide rails.
Figure 18 Installing the switch by using front mounting brackets and slide rails
(1) Front mounting bracket
Attach the front mounting brackets to the front square-holed brackets of the rack by using the M6
5.
screws and cage nuts. Make sure the switch is secured to the rack through the front mounting
brackets and slide rails.
NOTE:
Keep a distance of at least 1 U (44.45 mm/1.75 in) between two devices to ensure good heat dissipation.
(2) Front square-holed bracket
16
Figure