Figure 4 Mounting the switch on a workbench
Installing the switch in a 19-inch rack
The switch can be installed in a standard 19-inch rack. Installation falls into one of the following
scenarios:
•
Installing the switch with front and rear mounting brackets.
Installing the switch with front mounting brackets and a rack shelf.
•
Installing the switch with front mounting brackets and slide rails.
•
NOTE:
The front mounting brackets can be used only for securing the switch, rather than bearing weight.
•
You can install the mounting brackets to the two sides of the front panel or rear panel. This section
•
installs the mounting brackets to the two sides of the front panel.
Mounting brackets
Figure 5 Front mounting bracket
(1) Screw holes for fixing the front mounting bracket onto the rack (using M6 screws)
(2) Screw hole for fixing the front mounting bracket to the switch chassis
10