Conflict With Other Controls - Daikin DCM601A51 Commissioning Manual

Conflict with other controls

The following describes the operation when another control comes into conflict with the Leakage
Check.
Target
management Other control
point
Outdoor Communication
unit status
System
Indoor Central
unit Monitoring
* operation
Automatic
Control
Data
collection
System
* Refers to indoor units registered in the same refrigeration system as the target outdoor unit. In this table,
Enabled/Disabled applies if at least one indoor unit among those registered is in the relevant status.
79
Leakage
Check
Communication
×
error
Under
Maintenance
Stop
Start
Equipment error
Communication
error
Schedule Control
Interlocking Control
Emergency
×
Stop Control
Auto Changeover
Temperature
Limit
Sliding Temperature
HMO
Timer Extension
Setback
Power Proportional
Distribution
Energy
Navigator
Under
Maintenance
Commissioning Manual EM11A021
DCM601A51 intelligent Touch Manager
Mgmt. point
status/Other
control
If the outdoor unit experiences
communication error within 180
minutes of starting Leakage
Check, "Leakage Check failure" is
recorded in the history.
Settings modifications from the
× Maintenance Setup screen is not
allowed during Leakage Check.
× Central Monitoring operations are
not carried out during Leakage
×
Check since indoor units are under
×
maintenance.
×
Automatic Control is disabled
×
during Leakage Check since
indoor units are under
×
maintenance.
Emergency Stop instructions are
sent also to indoor units under
Leakage Check.
Automatic Control is disabled
×
during Leakage Check since
×
indoor units are under
maintenance.
×
×
×
×
Indoor units become under
maintenance during Leakage
Check (however, data can be
collected even under
maintenance)
Indoor units become under
maintenance during Leakage
×
Check (data collection is not
performed during maintenance).
Settings modifications from the
× Maintenance Setup screen is not
allowed during Leakage Check.
: Enabled ×: Disabled
Remarks