Fill Ink In The Ink Tank And Charging - MIMAKI SIJ-320UV Operation Manual

Chapter 1 Before Use
Fill ink in the ink tank
and charging
Fill ink in the ink tank of this machine.
• Be sure to wear the attached goggles and gloves
to perform the work. Ink may get in your eyes.
Rough standard for adding ink
You can check the current amount of ink in the ink tank of
this machine (rough standard) with the ink remaining
amount indicator below the ink tank.
The way to check the ink remaining amount indicator and
the ink remaining amount are as below.
In addition, when this machine enters into the status of
[Ink Near END] or [Ink End], the display indicate it.
Line of mouth for
• Notes before adding ink
• Check the following before adding ink. Failure to
do so could require all of the ink inside the ink
supply unit to be discarded.
• Type of ink
• Color of ink
• Expiration date of ink
Check both expiration dates of the ink contained in
the ink bottle for refilling and the ink tank of this
machine.
Check the label for the expiration date of the ink
bottle.
Press the [ENTER] key to check the expiration
date of the ink remaining in the ink tank of this
machine. (
1-10
Ink remaining amount indicator
P.3-22)
Status of ink
remaining amount
indicator
Status of ink Ink near end/
amount Ink end
Judgment for Adding is Adding is
adding possible. possible.
Current ink About 0 to About 400 to
*1 *2
amount 400cc 1800cc
Distance from
180mm and About 135mm
liquid level to
more and more
mouth for adding
*1. The ink remaining amount indicator is only rough standard. For ink
filling, it is recommended to check the liquid level from the mouth
for adding ink.
*2. 400 cc indicates [INK NEAR END] and 300 cc indicates [INK END].
*3. You can add ink up to 3.6L (liter) in the ink tank set in this machine.
However, ink may drop from the mouth for adding ink. When the
remaining amount indicator becomes completely red, do not add
ink.
1
Insert the ink IC chip into the ink IC slot.
• Use the IC chip attached to the ink bottle for
refilling.
• Insert the ink IC chip facing the contacts of IC chip
up.
• Do not dirty or damage the contact of ink IC chip.
It may cause not to read the stored information
correctly.
2
Confirm the information of ink IC chip, and
press the
• Confirm the color, ink type, capacity displayed on
the display. If incorrect, press [END/POWER] key
and reenter.
• When an error message such " WRONG INK IC "
is displayed, remove the IC chip once and reinsert
it.
• The ink IC chip charged once cannot be undone.
Be sure to press [ENTER] key after the displayed
information is confirmed.
3
Confirm the charge completion display.
• When the ink charging is normally completed, the
new ink ink expiration date is displayed.
• Reinsert the IC chip when an error occurs.
• Do not remove the ink IC chip or turn OFF the
power to this machine during charging. Doing so
may cause a failure to the equipment or the ink IC
chip.
Ink full
Adding is Adding is Adding is
possible. completed. completed.
About 1800 to About 2000 to About 3400 to
*3
2000cc 3400cc 3600cc
About 75mm About 75mm
About 130mm
and more and less
key.