Table of Contents
Advertisement
Chapter 5 Troubleshooting
Error messages
When an error message is displayed, eliminate the error according to the chart below.
If the same error message appears again, contact your dealer or an office of MIMAKI to call for service.
Message
ERROR 04
PARAM ROM
ERROR 108
HD CONNECT
ERROR 108
HD THERMIS
ERROR 108
HD MEM EMP
ERROR 108
HD TYPE
ERROR 128
HDC FIFO OVER
ERROR 128
HDC FIFO UNDER
ERROR 128
BATTERY EXCHANGE
ERROR 12a
HDC SPEED [12 ]
ERROR 12a
HEAD ROM WR
ERROR 12e
HeadFaild /HDC[**]
ERROR 130
HD DATA SEQ
ERROR 148
E-LOG SEQ
ERROR 151
Main PCB V1R2
ERROR 152
Main PCB V2R5
ERROR 153
Main PCB V3R3
ERROR 154
Main PCB V05
ERROR 155
Main PCB V36-1
ERROR 157
Main PCB VTT
ERROR 158
Main PCB V36-2
ERROR 15f
HEAD DRIVE HOT
ERROR 16e
Main PCB V3R3B
ERROR 171
NEW HEAD CONNECT
5-12
The PCB is defective.
Abnormal connection of the print head
[1234
]
Abnormal temperature of the print head
[1234
]
[1234
]
The print head has been broken.
[1234
]
Control circuit board is defective.
The battery life end of the internal clock is
detected.
Ink discharge control error
Head control error
The print head has been broken.
Control circuit board is defective.
An error occurred in the main power.
The temperature abnormality of control cir-
cuit board has been detected.
An error occurred in the main power.
Connection of a new head was recognized.
Cause
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
• Contact your local distributor to call for
service.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
Solution
Advertisement
Table of Contents
Need help?
Do you have a question about the SIJ-320UV and is the answer not in the manual?