Operating The Removable I.v. Pole; Installing The Upright Oxygen Bottle Holder - Stryker 1080 Operation Manual

OPERATING THE REMOVABLE I.V. POLE

To use the removable I.V. pole:
1. Remove the I.V. pole from the storage trough under the litter and insert
into the receptacle on the corner of the litter frame.
2. To raise the height of the pole, turn the knob (A) counterclockwise
and pull up on the telescoping portion (B) of the pole to raise it to the
desired height.
3. Turn the knob (A) clockwise to lock the telescoping portion in place.
CAUTION
• To avoid damage, the weight of the I.V. bags should not exceed 40 lb.
• To avoid damage while transporting the stretcher, verify that the I.V.
pole is at a low enough height to allow it to safely pass through door
openings and under light fixtures.
• Do not use the I.V. pole as a push/pull device because equipment
damage could occur.

INSTALLING THE UPRIGHT OXYGEN BOTTLE HOLDER

To install the upright oxygen bottle holder:
1. Insert the support bar (A) into the I.V. socket at any
of the four litter corners.
2. Insert the cotter pin (B) through the hole in the
support bar to hold the bottle holder in place.
CAUTION
• To avoid damage, do not put items weighing more
than 40 lb. in the upright oxygen bottle holder.
• Do not use the upright oxygen bottle holder as a
push/pull device because equipment damage could
occur.
www.stryker.com
Operation Guide
1080-009-001 REV A
B
A
Removable I.V. Pole
Upright Oxygen Bottle Holder
Return To Table of Contents
A
B
13