Table of Contents
Advertisement
Connecting your hardware
Read "Safety notices" on page v before you continue with
these instructions.
1. Connect the devices listed below to the appropriate
ports:
1 Network cable
2 USB keyboard and other USB devices
3 Mouse (connects to keyboard)
4 Headphones
5 Microphone
6 Monitor
7 Power supply and power cable
2. Ensure that the monitor cable is securely connected to
the NetVista thin client.
3. Plug any power cables into properly grounded
working electrical outlets.
Powering on your hardware
1. Power on the monitor and other devices that are
attached to the NetVista thin client.
2. Power on your NetVista thin client by pressing the
white power button 8 .
The system LED 9 quickly flashes from amber to a
solid green. Your NetVista thin client performs its
startup sequence. See "Startup sequence" on page 7
for more information.
3. Refer to the following sections for more information
on working with your NetVista thin client:
v "Configuring your thin client" on page 9
v "Working with the Terminal Connection Manager"
on page 33
v "Updating your software" on page 43
Powering off your hardware
1. Power off your NetVista thin client by pressing the
white power button 8 .
The system LED 9 flashes amber once shortly after
power off. This indicates that your NetVista thin client
has automatically enabled Wake-On-LAN (WOL).
2. Power off your monitor and other devices that are
attached to your NetVista thin client.
6
IBM NetVista N2200w, Thin Client for WBT Standard 1.5 Reference
Advertisement
Table of Contents
