IBM NetVista N2200w Reference Manual page 69

Table 16. NSBxxxx error codes and text messages (continued)
Error code
NSB31510 Keyboard controller did
not respond.
NSB31520 Keyboard was not
recognized.
NSB32500 Mouse did not respond.
NSB40500 USB failure.
NSB40510 USB initialization failure.
CompactFlash card messages (NSB51xxx)
NSB51500 File not found on flash
card.
NSB51510 Cannot close file on flash
card.
NSB62500 Line speed automatic
negotiation failed.
NSB62510 No network device found. Replace the NetVista thin client logic unit
NSB83589 Failed to boot after 3
attempts.
Error message
Check the keyboard cable connection. If
the symptom remains, replace the NetVista
thin client logic unit (see "Appendix A.
Replacing hardware parts" on page 59).
Check the keyboard cable connection.
Check the mouse cable connection.
USB messages (NSB4xxxx)
Disconnect any USB devices from the
NetVista thin client and restart the system.
If the symptom remains, replace the
NetVista thin client logic unit (see
"Appendix A. Replacing hardware parts"
on page 59).
Disconnect any USB devices from the
NetVista thin client and restart the system.
If the symptom remains, replace the
NetVista thin client logic unit (see
"Appendix A. Replacing hardware parts"
on page 59).
Power off the NetVista thin client. Ensure
that the CompactFlash card is installed
properly (see "Appendix D. CompactFlash
card" on page 67). Power on the NetVista
thin client. If the hardware problem
persists, replace the NetVista thin client
logic unit (see "Appendix A. Replacing
hardware parts" on page 59).
Power off the NetVista thin client. Ensure
that the CompactFlash card is installed
properly (see "Appendix D. CompactFlash
card" on page 67). Power on the NetVista
thin client. If the hardware problem
persists, replace the NetVista thin client
logic unit (see "Appendix A. Replacing
hardware parts" on page 59).
Ethernet messages (NSB62xxx)
Verify that you connected the network
cable to the NetVista thin client correctly.
(see "Appendix A. Replacing hardware
parts" on page 59).
Failure to boot message (NSB83xxx)
Power off the NetVista thin client. Ensure
that the CompactFlash card is installed
properly (see "Appendix D. CompactFlash
card" on page 67). Power on the NetVista
thin client. If the hardware problem
persists, replace the NetVista thin client
logic unit (see "Appendix A. Replacing
hardware parts" on page 59).
What you should do
Resolving hardware problems
57