Table of Contents
Advertisement
1. Close all active terminal server connections. Refer to "Disconnecting from a
2. From the Terminal Connection Manager window, press F2 to access the
3. From the Terminal Properties window, click the Export tab.
4. Enter the URL of the configuration server and directory in the WBT Update
5. Click Export Now.
6. Verify that the Saveconfig.reg file and the correct number of .SES files (1 per
7. Click OK on the dialog box that appears.
Attention: Each time you export your terminal configuration on your
configuration server directory, your NetVista thin client overwrites any existing
Saveconfig.reg file. IBM recommends that you set up and specify a different
directory each time you plan to export a base terminal configuration. Depending
on your work, area, or network requirements, you can save different base terminal
configurations for different groups of users in your organization.
28
IBM NetVista N2200w, Thin Client for WBT Standard 1.5 Reference
terminal server" on page 34 for more information.
Terminal Properties window.
URL box.
The following URL guidelines apply:
v Use FTP as the transfer protocol.
v Use either the IP address or the server name of your update server.
v Specify the configuration server directory where you need to store the export
file.
For example:
ftp is the transfer protocol.
d.d.d.d is the IP address of your configuration server.
wbt_config is the configuration server directory
where you need to store the export file, Saveconfig.reg.
Your NetVista thin client exports your terminal configuration into an export
file, Saveconfig.reg, that is saved on the configuration server. If you have TEC
connections, your NetVista thin client also saves an .SES file for each TEC
connection onto your configuration server.
For example, if your base NetVista thin client has three TEC connections when
you exported its terminal configuration, your configuration server directory
should list three .SES files, in addition to the Saveconfig.reg file. If you did not
export any TEC connections, your configuration server directory should not list
any .SES files.
Emulation) is saved on your configuration server.
ftp://d.d.d.d/wbt_config
Advertisement
Table of Contents
