Table of Contents
Advertisement
Setting up your hardware
The IBM NetVista Quick Setup Type 8363 (SA23-2800) pamphlet, which ships with your hardware, provides the
following information. This section repeats the same information for your convenience.
Read "Safety notices" on page v before you continue with these instructions.
Unpacking your hardware
Unpack the hardware. Contact your reseller, or IBM, if
you do not have these standard parts:
1 Logic unit
2 Base
3 Mouse
4 USB Keyboard
5 Power supply
6 Power cable
Options:
v If you have additional memory cards, read
"Appendix C. Upgrading memory" on page 65 first,
and then continue with "Installing the support base".
v If you would like to restrict access to the logic unit,
you can thread a security cable through tab A .
Installing the support base
Read "Safety notices" on page v before you continue with
these instructions.
IBM recommends that you install the hardware in a
vertical position.
1. Align the notches B on the support base C with
the holes on the bottom of the logic unit D .
2. Slide the support base C onto the bottom of the
logic unit D .
To remove the support base C , lift the latch on the
support base and slide the support base off of the
logic unit D .
© Copyright IBM Corp. 2000, 2001
5
Advertisement
Table of Contents
