Derby cycle Pedelec Impulse Evo User Manual page 12

The recommendation is to remove the key now and keep it
in a safe place so it does not break off and is not lost.
Make a note of the key number on the sales receipt/
document. This number can be used to order a replacement
key  7.2 Battery Page
2.3 Switching on the Pedelec
1. Press for 1 second the button on the
easy-reach control. The display lighting
is switched on for about 30 seconds.
The back light is also turned on. The
front light is turned on when it has been
switched on from the top of the lamp.
After a short time, a welcome screen is
shown, followed by the start menu. If you
have an Impulse Evo System with back
pedal, "Please pedal" is shown. You can
configure other settings from the start
menu.
EN-12 Original User Guide | Pedelec Impulse Evo Version 1
EN-60.
Press the button
If the cycle does not start up despite you
pressing the button, press the battery
button for 1 second. Then briefly press the
button on the easy-reach control. The
Pedelec switches on. If it still does not
switch on, check the battery
 5.2.1 Battery management system (BMS)
Page EN-47.
2.4 Changing assist mode
1. You must be in the start menu to change assist mode. Briefly press the
/ buttons to select the assist level.
DISPLAY ASSIST
POWER
The assist function works very hard
SPORT
The assist function works medium
hard
ECO
The assist function works with low
power
OFF
No assist
Battery
button
POWER CONSUMPTION
High
Medium
Low
Very low