Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Derby cycle Pedelec
Summary of Contents for Derby cycle Pedelec
- Page 1 User manual Pedelec...
- Page 2 Battery with battery status indicator Battery lock Pedal gear with motor unit Control switch with assistance operating switch and battery status indicator Charging station Danger symbol: Indications with this symbol Cautionary symbol: Indications warn of possible bodily injury, in particular with this symbol warn of possible material due to greater danger of falling or other increased risk of injury.
-
Page 3: Charging The Battery
Dear Customer: Power assistance is not available if: You have decided in favour of a Pedelec (Pedal Electric Cycle) - a bicycle that is equipped with an electric motor to give you additional assistance when riding. ● the pedalling power is too weak Characteristics ●... -
Page 4: Charging Process
Charging process Comments 1. Plug the charging device into a 220 volt ● Make sure that the battery is fully charged before the first ride or after the bicycle has not socket. Grasp the battery and insert it into been used for longer than one month. The battery is not charged when delivered. the slot provided for it on the charging station. -
Page 5: Operation
Battery Available capacity Control panel Operation Control panel % 20 40 80 100 On/Off The electronic power assistance is Check battery Battery status switch switch on and off by using a switch status indicator mounted on the handlebars. Push Selection of Battery („Power“) assistance... -
Page 6: Recommended Gear
LED status on the control panel W hen necessary, set the accessory motor to high mode. If no pedalling is LEDs on The battery has a charge sufficient for your trip. necessary when riding downhill, the accessory motor will switch off automatically. The available battery capacity is indicated by the lighting up of the corresponding LED. -
Page 7: Battery Tips
For stopping The battery must be fully charged at least every six months - otherwise Neither the gearshift nor the mode switch should be activated. irreparable damage may occur. ● First activate the rear wheel brake or front wheel brake and rear wheel brake simultaneously. -
Page 8: General Information On The Charger
Discharge characteristic curve (temperature) General information on the charger Discharge curve for regular temperature The delivery includes the type NKJ38 charger. Before use, take the charger out of the cardboard box and remove the plastic wrapping. If you do not do this, the Discharge curve for lower temperature outside of the charger can be deformed by the heat. -
Page 9: Troubleshooting
Blinking interval - a field corresponds to 0.5 sec Errors Blinking LEDs Comment Upper power diode Indicates remaining battery capacity. Self configuration Middle power diode Lower power diode Directly after switching on “High” mode start support mode “Medium” mode and further “Low”... -
Page 10: Fehlersuche
Fehlersuche Problem Cause Item to be checked Problem Cause Item to be checked current cannot be 1) No remaining battery 1) check the battery Weak assistance 1) Capacity drop due to 1) Have the voltage on the switched on capacity charge status indicator battery ageing battery terminal checked... -
Page 11: Technische Daten
EEC directives: Electro Magnetic Compatibility Directive (89/336/EEG). Copyright © 2007 Derby Cycle Werke GmbH Low Voltage Directive (73/23/EEC and Reproduction, even in excerpts, only with the authorization of Derby Cycle Werke 93/68/EEC). GmbH, printing errors, mistakes and technical modifications reserved!
Need help?
Do you have a question about the Pedelec and is the answer not in the manual?
Questions and answers