Table of Contents
Advertisement
Chapter 5 Maintenance and Troubleshooting
To replace a power supply:
1. With the bezel and fan tray assembly removed, insert the power supply into the chassis
until it engages with the connector, as shown in
Figure 5–9: Replacing a Power Supply
2. If necessary, use a Phillips-head screwdriver to attach the bracket to the right inside of the
chassis, as shown in
3. Reinstall the fan tray assembly, as described in
4. Reinstall the bezel, as described in
5. Connect power to the power supply.
Input/Output Modules
To extend the capability of the Electra 9200, there are 5 slots for optional input/output
modules in the rear of the chassis. These provide additional audio encoding capabilities,
audio & video decoding, or transport stream input/output options. Refer to
additional information on each of these modules.
NOTE: Before making changes to the FLEX-1 Module, make sure the service configuration is cleared
before powering down the system.
© 2015 Harmonic Inc. All rights reserved.
Figure
5–9.
Removing and Replacing the
45
Figure
5–9.
Removing and Replacing the Fan
Bezel.
Optional Features
Input/Output Modules
(RN-15)
Tray.
for
Electra 9200, Rev O
Hide quick links:
Advertisement
Table of Contents
