Harmonic Electra9200 Installation Manual page 106

Appendix E Safety and Regulatory Compliance
Information
Le personnel du recycleur doit avoir de l'expérience des outils de démontage de l'appareil. Les
produits Harmonic ne doivent pas être démontés par du personnel non qualifié. Une mauvaise
connaissance des outils peut causer des dommages et des blessures.
EU Manufacturer's Declaration of Conformity
This equipment is in compliance with the essential requirements and other provisions of
Directives 73/23/EEC and 89/336/EEC as amended by Directive 93/68/EEC.
NOTE: For specifics, about which standards have been applied, refer to the Declaration of Conformity of
the product on Harmonic website at
at regulatory.compliance@harmonicinc.com
Electromagnetic Compatibility Notices – Class A
a. FCC Verification Statement (USA)
This device complies with Part 1 5 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 1 5 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case users
will be required to correct the interference at their own expense.
Connections between the Harmonic equipment and other equipment must be made in a
manner that is consistent with maintaining compliance with FCC radio frequency
emission limits. Modifications to this equipment not expressly approved by Harmonic may
void the authority granted to the user by the FCC to operate this equipment and you may
be required to correct any interference to radio or television communications at your own
expense.
b. ICES–003 Statement (Canada)
English: This Class A digital apparatus complies with Canadian ICES-003.
French: Cet appareil numérique de la classe A est conforme à la norme NMB-003 du
Canada.
c. CE Declaration of Conformity (European Union)
This product has been tested in accordance too, and complies with the Low Voltage
Directive (201 4/30/EU) and EMC Directive (201 4/35/EU). The product has been marked
with the CE Mark to illustrate its compliance.
© 2015 Harmonic Inc. All rights reserved.
Product Regulatory Compliance
99
EU Manufacturer's Declaration of Conformity
or contact Harmonic Compliance Team
Electra 9200 Release XXX, Rev O