Two Channel Flex System; Four Channel Flex System - Harmonic Electra9200 Installation Manual

Chapter 7 FLEX Decoding Module

Two Channel FLEX System

Figure 7–2 illustrates a typical 2-channel re-encode chassis cabling assignment. This setup
uses a one- or two-channel encoder chassis.
associations.
Figure 7–2: Two Channel Re-Encode Chassis (Cable) Setup
Table 7–2: Port and Cable Assignments (two-channel)
Port
Monitor 1
Slot 4
Monitor 2
Slot 4
NOTE: The FLEX-1 Module in this configuration must use slot 4.

Four Channel FLEX System

Figure 7–3 illustrates a typical four channel re-encode chassis cabling assignment. This setup
uses a base three or four channel encoder chassis.
Figure 7–3: Four-Channel Re-Encode Chassis (Cable) Setup
Table 7–3: Port and Cable Assignments (four-channel)
Port
Monitor 1
Slot 4
Monitor 2
Slot 4
Monitor 1
Slot 5
© 2015 Harmonic Inc. All rights reserved.
Description
75  cable. The Monitor 1 output port can be used
for monitoring and troubleshooting purposes.
75  cable. The Monitor 2 output port can be used
for monitoring and troubleshooting purposes.
Description
75  cable. The slot 4 Monitor 1 output port can be
used for monitoring and troubleshooting purposes.
75  cable. The slot 4 Monitor 2 output port can be
used for monitoring and troubleshooting purposes.
75 cable. The slot 5 Monitor 1 output port can be
used for monitoring and troubleshooting purposes.
63
describes the port and cable
Table 7–2
Slot 4
Slot 4 Slot 5
Cabling the FLEX-1 Module
(RN-22)
Connector
DIN 1.0/2.3
DIN 1.0/2.3
(RN-23)
Connector
DIN 1.0/2.3
DIN 1.0/2.3
DIN 1.0/2.3
Electra 9200, Rev O