Output Specifications; Environmental And Physical; Installing The Flex-1 Decoding Module; Esd Safety Precautions - Harmonic Electra9200 Installation Manual

Chapter 7 FLEX Decoding Module

Output Specifications

Table 7–12 describes the output specifications supported by the FLEX-1
Table 7–12: Outputs Specifications
Video Outputs
Connector Type
Embedded Data along the
Video

Environmental and Physical

Compliant with ROHS Directive 2002/95/EC. For additional information,
Specifications

Installing the FLEX-1 Decoding Module

This section describes how to install the FLEX Decoding Module. The module's ports are
shown in
Figure
Host encoders are typically ordered from the factory with the FLEX-1 Module already
installed.

ESD Safety Precautions

To protect modules from electrostatic discharge (ESD), follow these safety precautions:
Always wear a properly grounded antistatic wrist strap whenever handling the modules.
n
Keep the module inside the antistatic bag until you are ready to install the module in a
n
chassis.

Installing a Module

Refer to
Removing and Replacing an Input/Output(I/O) Module
module.
© 2015 Harmonic Inc. All rights reserved.
Feature
n
n
n
n
7–1.
Support
One (1) per decoded channel with video only, via
internal midplane
One (1) per channel for confidence monitoring only
DIN 1.0/2.3 (DIN 1.0/2.3 to BNC modules available)
No Audio, VBI, VANC or HANC data embedded in the
SD/HD monitoring outputs. This data is passed via the
internal mid-plane connection.
for instructions on how to install a
70
Output Specifications
module.
Environment
Electra 9200, Rev O