Ip Input And Output Support And Specifications - Harmonic Electra9200 Installation Manual

Chapter 4 Electra 9200 Specifications
Encapsulation mode is controlled by selecting "MPEG-2" or "MPEG-4" as required.

IP Input and Output Support and Specifications

The IP Input on the chassis provides a Transport Stream input to the FLEX Decoder Module
from an IP network. Dual GbE IP inputs support various input redundancy configurations.
Table 4–7: IP (GbE) Input
Type
IP ports
Connector
Speed
IP encapsulation
MPEG format
MPEG-2 TS
Maximum Bit-Rate per
Socket
Addressing
Management
Forward Error Correction
(FEC)
Table 4–8: IP (GbE) Output
Type
IP ports
Connector
Speed
IP encapsulation
MPEG format
MPEG-2 TS
Maximum Bit-Rate
Addressing
Management
© 2015 Harmonic Inc. All rights reserved.
Feature
Gigabit Ethernet
Two independent ports
Two × RJ-45 ports
One × 10/100/1000 Mbps per port
MPEG-2 TS over UDP/IP 1 to 7 TS/ IP
188 or 204 bytes per TS packet
MPTS and SPTS
100 Mbps
Unicast and multicast
IGMP, ARP, and ICMP
The GbE input supports SMTE 2022-1 and -2 forward error
correction (FEC). FEC provides lost packet recovery at the
receiving devices.
Feature
Gigabit Ethernet
Two independent ports
Two × RJ-45 ports
One × 100/1000 Mbps per port
MPEG-2 TS over UDP/IP 1 to 7 TS/ IP
188 bytes per TS packet
MPTS and SPTS
180 Mbps
Unicast and multicast
IGMP, ARP, and ICMP
Support
Support
33
Audio Encoder Features
Electra 9200, Rev O