Messages When Resetting The Encoder; Front Panel Leds - Harmonic Electra9200 Installation Manual

Chapter 2 Installing the Encoder
NOTE: During the boot sequence, do not press any key on the keypad.
The following sequence describes the display on the vacuum fluorescent display (VFD) during
a successful startup:
Power on
n
VFD line 1 = Harmonic Logo
Begin loading
n
VFD line 1 = Initializing
Configuring
n
VFD line 1 = MAC Address xx:xx:xx:xx:xx
Booting
n
VFD line 1 = BootP 1–4 (screen updates 1,2,3,4)
VFD line 2 = Boot From Hard Drive
Finished
n
VFD line 1 = Electra 92xx
VFD line 2 = Multichannel Encoder
The local control panel displays messages for other types of restarts, including a system reset
and loading new software.

Messages When Resetting the Encoder

When you reset the encoder from NMX, a message on the VFD shows that the encoder has
been reset. The encoder uses the boot file on the hard drive when you reset it.
Reset from NMX
n
VFD line 1 = Bye bye...
VFD line 2 =
After power cycle
n
VFD line 1 = Harmonic Inc
VFD line 2 = System Loading
Begin loading
n
VFD line 1 = Electra 9xxx
VFD line 2 = System Loading
Booting
n
VFD line 1 = Electra 9xxx
VFD line 2 = Loading xxxxxxxx.elf
Finished
n
VFD line 1 = Electra 92xx
VFD line 2 = Multichannel Encoder

Front Panel LEDs

The four LEDs on the front panel indicate the operational state of the encoder.
describes the front panel LEDs.
© 2015 Harmonic Inc. All rights reserved. 20
Front Panel LEDs
Table 2–3
Electra 9200, Rev O