Appendix C: Encoder Back Panel Slot Specifications - Harmonic Electra9200 Installation Manual

Appendix C Encoder Back Panel Slot Specifications
This appendix contains the back slot specifications.
Module Slots
The diagram below represents the back panel of the dual power supply model of the Electra
9200 (ELC-9200D). The diagram shows the slot number and the modules that can be
installed in that slot. NMX uses the slot number to differentiate between cards of the same
type within the encoder.
Figure C–1: Module slots.
Module Configurations for All Encoders
Table C–2: Module Configurations
Slot1
FLEX-1
AHC-RAC X
AHC-561 X
8VSB X
ASI Out
ASI In X
AB PWR X
© 2015 Harmonic Inc. All rights reserved.
Encoder Back Panel Slot Specifications
Slot 3 Slot 4
Slot 1 Slot 2
Slot 2 Slot 3 Slot 4
X
X X X
X X X
X X
X
X X
X
Slot 5
Slot 5
X 1 or 2 per chassis
X 1 to 5 per chassis
1 to 4 per chassis
Note: Cannot be used with FLEX.
1 per chassis
X 1 per chassis
1 per chassis
1 per chassis - Needs both slots
83
Module Slots
Appendix C
(RN-24)
Electra 9200, Rev O