Configuring The Flex-1 Module In Nmx; Video Decoding Specifications - Harmonic Electra9200 Installation Manual

Chapter 7 FLEX Decoding Module
Table 7–3: Port and Cable Assignments (four-channel)
Port
Monitor 2
Slot 5

Configuring the FLEX-1 Module in NMX

Refer to the NMX online help system for configuring a FLEX-1 Module for use in your NMX
Digital Service Manager application.

Video Decoding Specifications

describes video decode specifications supported by the FLEX-1
Table 7–4
NOTE: The Electra 9200 also supports auto-format detection and switching (within 30 seconds).
Table 7–4: Video Decoding Features
Video Decoding
Aspect Ratios
Video Formats
Bit Rates
Downconversion
Auto Format Detection
a. Requires an optional firmware license.
© 2015 Harmonic Inc. All rights reserved.
Description
75  cable. The slot 5 Monitor 2 output port can be
used for monitoring and troubleshooting purposes.
Feature
n
n
n
n
n
n
n
480i/29.97, 576i/25, 720p/59.94 720/50, 1080i/25,
1080i/29.97
AVC max bit rate: 24 Mbps
MPEG-2 max bit rate: 50 Mbps
HD decode and downconvert to SD
n
n
n
n
n
n
Support
MPEG-2 MP@ML
MPEG-2 MP@HL
MPEG-4 AVC MP@L3
MPEG-4 AVC HP@L4
VBR, CBR
AVC SD and HD
4:3 and 16:9
a
60 HZ conversions between 3 specific formats: 1080i/
29.97 or 720p/59.94 to 480i/29.97
50 Hz conversions between 3 specific formats: 1080i/
25 or 720p/50 to 576i/25
Static conversion or controlled by AFD/Bar data
Automatically switch between 1080i and 720p formats
when the HD-SDI input changes formats
Switch performed within 30 seconds
Not supported with downconversion
64
Configuring the FLEX-1 Module in NMX
Connector
DIN 1.0/2.3
Module.
Electra 9200, Rev O