Mg-Sip Programming In Sample Network - NEC MG-SIP Configuration Manual

Session initiated protocol
Table of Contents

Advertisement

AMGIL
MG-ID: 00-60-B9-46-4B-AE (MG-SIP Line 0 MAC Address)
KIND = SIP-MG
LINE = 0
CH = 0
LENS: 072120
Retry = 0
Service Type: Off
CH: 16
Service of Authentication exists: Yes (NOTE: If "Yes", must assign ASRIL)
MG Group = 1
MG Number = 1
ASRIL
(This Command not needed of AMGIL "Service of Authentication exists = No")
MG Group = 1
MG Number = 1
CNT: Start = 1
End = 2
CNT: 1, Calling Number: 5020, SIP URI: 9725551234, UserID: (userID of SIP Trunk Group), Password: (password of SIP Trunk Group)
CNT: 2, Calling Number: 5004, SIP URI: 9725551235, UserID: (userID of SIP Trunk Group), Password: (password of SIP Trunk Group)
ACDD
DAY/NIGHT: Day/Night Mode
RT: 200
DC: 1236 / 1235
CDC: 5020 / 5004
AD: Out of Service
XFR: In Service
A-3 MG-SIP Programming in Sample Network
MAC Data
Ether[1]
MAC Address : 00-60-b9-46-4b-ae (built into MG-SIP, not assigned by user)
Ether[2]
MAC Address : 00-60-b9-46-4b-6e (built into MG-SIP, not assigned by user)
DRS Data
DRS[0] IP Address : 50.51.52.70 : PortNo[3456]
DRS[1] IP Address : 0.0.0.0 : PortNo[3456]
DRS[2] IP Address : 0.0.0.0 : PortNo[3456]
DRS[3] IP Address : 0.0.0.0 : PortNo[3456]
Common Config Data
set signaling_port_no :
Signal port number
--------------------------------------------
set registration_port_no :
Registration port number
--------------------------------------------
set pre_negotiation_port_no :
Voice path port number
--------------------------------------------
set ipx_rtp_port_no :
IPX side RTP port number
--------------------------------------------
set sip_rtp_port_no :
SIP side RTP port number
--------------------------------------------
set h245_base_port_no :
H245 base port number
--------------------------------------------
MG-SIP
: 61012
: 3456
: 61014
: 51000
: 50000
: 40000
Page 70 of 75
5/8/2009

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents