Setδsip_Route; Setδsip_Rtp_Port_No; Setδsip_Server - NEC MG-SIP Configuration Manual

•
When IP address (=0) is selected:
•
When FQDN (=1) is selected:
Note: Be sure not to enter a space after FQDN characters.
7.5.3.39 SETΔSIP_ROUTE
This command is used to specify route information in the SIP side network. The registered number of the route
information is up to 10. Pressing the Enter key can skip the item. In this case, default values are assigned
automatically. To make this assignment effective, it is required to execute the "REBOOT" command
MG-SIP16.
7.5.3.40 SETΔSIP_RTP_PORT_NO
This command is used to specify the RTP port base number from SIP network. Pressing the Enter key can skip the
item. In this case, default values are assigned automatically. To make this assignment effective, it is required to
execute the "REBOOT" command to restart the MG-SIP16.
Note: The value must be assigned by an even number.
7.5.3.41 SETΔSIP_SERVER
The command is used to assign an IP address or a Fully Qualified Domain Name (FQDN) to the SIP server. Pressing
the Enter key can skip the item. (Note) In this case, default values are assigned automatically. To make this
assignment effective, it is required to execute the "REBOOT" command to restart the MG-SIP16.
Note: "SIP server type" and "IPaddress/FQDN" cannot be skipped.
MG-SIP Page 48 of 75
to restart the
5/8/2009