Setδsip_Tel_Service - NEC MG-SIP Configuration Manual

•
When IP address (=0) is selected:
•
When FQDN (=1) is selected:
Note: Be sure not to enter a space after FQDN characters.
7.5.3.42 SETΔSIP_TEL_SERVICE
The command is used to enable/disable the use of additional service features (Hold/Retrieve/Transfer from the SIP
network side terminal). Pressing the Enter key can skip the item. In this case, default values are assigned
automatically. To make this assignment effective, it is required to execute the "REBOOT" command to restart the
MG-SIP16.
MG-SIP Page 49 of 75 5/8/2009