Setδipx_Route - NEC MG-SIP Configuration Manual

Note: When the IP addresses of both LAN and WAN are assigned in the same segment, use Ether1 port only.
Select one port in the number of port setting, and assign Ether1's IP address only. In this case, Ether2 is not used.
Note: When the IP addresses of IPX network and SIP network are assigned in the same segment, use Ether1 only
as shown on next page.
7.5.3.21 SETΔIPX_ROUTE
This command is used to specify route information in the PBX side network. The registered number of the route
information is up to 10. Pressing the Enter key can skip some of the items. In this case, default values are assigned
automatically. To make this assignment effective, it is required to execute the "REBOOT" command to restart the
MG-SIP16.
•
When Exit (Route type = 0) is selected:
MG-SIP Page 37 of 75 5/8/2009