Setδout_Of_Area_Code; Multisession; Show Commands; Showδarp - NEC MG-SIP Configuration Manual

7.5.3.46 SETΔOUT_OF_AREA_CODE
This command is used to set the error response code to inform out-of-area-code on PBX network side. Pressing the
Enter key can skip the item. To make this assignment effective, it is required to execute the "REBOOT" command
to restart the MG-SIP16.

7.5.3.46 MULTISESSION

This command is used to enable/disable the use of Multi-Path Switch in ACD system by using MG-SIP. To make
this assignment effective, it is required to execute the "REBOOT" command to restart the MG-SIP16.

7.5.4 SHOW COMMANDS

7.5.4.1 SHOWΔARP
This command is used to show the Address Resolution Protocol (ARP) table. The following shows a sample display.
Note
Note: Actual value may differ from this sample.
MG-SIP Page 51 of 75 5/8/2009